‏מיקרופון קונדנסר Audio Technica PRO35 אודיו טכניקה

מיקרופון קונדנסר קרדיואידי עם תפס לכלי נגינה

Designed for sax, toms, brass and percussion, the PRO 35 excels in high-SPL applications and is ideal for active stage performances. Its extended frequency response captures subtle nuances of the performance. The included UniMount® clip permits accurate positioning and provides shock resistance while protecting the element. The microphone’s cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source
UniMount® clip permits accurate positioning, provides shock resistance and protects element
Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source
Extended frequency response captures subtle nuances of the performance

1.8m cable permanently attached between microphone and power module

SPECIFICATIONS

ELEMENT Fixed-charge back plate, permanently polarized condenser
——————————————————————————–
POLAR PATTERN Cardioid
——————————————————————————–
FREQUENCY RESPONSE 50-15,000 Hz
——————————————————————————–
LOW FREQUENCY ROLL-OFF 80 Hz, 18 dB/octave
——————————————————————————–
OPEN CIRCUIT SENSITIVITY -45 dB (5.6 mV) re 1V at 1 Pa
——————————————————————————–
IMPEDANCE 250 ohms
——————————————————————————–
MAXIMUM INPUT SOUND LEVEL 145 dB SPL, 1 kHz at 1% T.H.D
——————————————————————————–
DYNAMIC RANGE (typical) 115 dB, 1 kHz at Max SPL
——————————————————————————–
SIGNAL-TO-NOISE RATIO 64 dB, 1 kHz at 1 Pa
——————————————————————————–
PHANTOM POWER REQUIREMENTS 11-52V DC, 2 mA typical
——————————————————————————–
SWITCH Flat, roll-off
——————————————————————————–
WEIGHT (MICROPHONE) 8 g
——————————————————————————–
WEIGHT (POWER MODULE) 81 g
——————————————————————————–
DIMENSIONS (MICROPHONE) 25.0 mm-long,  10.2 mm-diameter
——————————————————————————–
DIMENSIONS (POWER MODULE) 92.9 mm-long,  18.9 mm-diameter
——————————————————————————–
OUTPUT CONNECTOR (POWER MODULE) Integral 3-pin XLRM-type
——————————————————————————–
CABLE 1.8 m-long (permanently attached to microphone), 2.6 mm-diameter, 2-conductor, shielded cable with TA3F-type connector